JVC KS-AX3204 Instructions Manual
Power amplifier
Hide thumbs
Also See for KS-AX3204:
- Instruction manual (6 pages)
Advertisement
KS-AX3204
KS-AX3202
KS-AX3201D
POWER AMPLIFIER: INSTRUCTIONS
УСИЛИТЕЛЬ МОЩНОСТИ: ИНСТРУКЦИИ ПО ЭКСПЛУАТАЦИИ
[K]
ENGLISH
Thank you for purchasing a JVC product.
If you have any questions or require information regarding installation kits, consult your "JVC IN-
CAR ENTERTAINMENT" or a company supplying the kits.
For safety....
CAUTIONS AND NOTES
This unit is designed to operate on 12 V DC, NEGATIVE ground electrical systems.
JVC recommends consulting a qualified technician for installation.
so comply with the following:
– Do not connect the "
" terminals of the speakers to each other.
– Do not connect the "
with insulating tape.
the old fuse with one with the same rating.
periodically.
engine is idling.
INSTALLATION
corresponding to your specific car.
Å
Location of the unit
Onto the trunk floor
Under the front seat
ı
Install the unit
Provided screw
φ 4 × 20 mm (
13
/
in.)
16
Drilled hole
SAFETY INSTRUCTIONS
"SOME DOS AND DON'TS ON THE SAFE USE OF EQUIPMENT"
This equipment has been designed and manufactured to meet international safety standards but, like any electrical
equipment, care must be taken if you are to obtain the best results and safety is to be assured.
DO read the operating instructions before you attempt to use the equipment.
DO ensure that all electrical connections (including the mains plug, extension leads and interconnections between
pieces of equipment) are properly made and in accordance with the manufacturer's instructions. Switch off and
withdraw the mains plug when making or changing connections.
DO consult your dealer if you are ever in doubt about the installation, operation or safety of your equipment.
DO be careful with glass panels or doors on equipment.
DON'T continue to operate the equipment if you are in any doubt about it working normally, or if it is damaged in any
way–switch off, withdraw the mains plug and consult your dealer.
DON'T remove any fixed cover as this may expose dangerous voltages.
DON'T leave equipment switched on when it is unattended unless it is specifically stated that it is designed for
unattended operation or has a standby mode. Switch off using the switch on the equipment and make sure that your
family know how to do this. Special arrangements may need to be made for infirm or handicapped people.
DON'T use equipment such as personal stereos or radios so that you are distracted from the requirements of traffic
safety. It is illegal to watch television whilst driving.
DON'T listen to headphones at high volume as such use can permanently damage your hearing.
DON'T obstruct the ventilation of the equipment, for example with curtains or soft furnishings. Overheating will cause
damage and shorten the life of the equipment.
DON'T use makeshift stands and NEVER fix legs with wood screws–to ensure complete safety always fit the
manufacturer's approved stand or legs with the fixings provided according to the instructions.
DON'T allow electrical equipment to be exposed to rain or moisture.
ABOVE ALL
— NEVER let anyone, especially children, push anything into holes, slots or any other opening in the case — this could
result in a fatal electrical shock.
— NEVER guess or take chances with electrical equipment of any kind–it is better to be safe than sorry!
trunk or under the front seat.
mount it in an area that will not prevent the unit
from dissipating the heat.
heat: near a radiator, in a glove compartment or
in insulated areas such as under a car mat that
will prevent the unit from dissipating heat.
not catch any wire of the unit.
provided screws.
loosening the unit or damaging the parts under
the car floor.
unit, make sure that there is a sufficient space
under the trunk so that you do not drill holes in
the fuel tank, etc.
E43486-340B
POWER SUPPLY
KS-AX3204
KS-AX3202
KS-AX3201D
Fuse*
Ignition switch
Caution
disconnected.
shown.
"
The proper lead wire connected to each POWER terminal is as follows.
a When you use JVC car receiver with a remote lead, connect to the REM terminal on this unit.
b When you connect a unit without a remote lead, connect to the accessory circuit of the car
is turned on or off. To avoid this noise, do not turn on or off the car receiver itself. You can turn
on or off the car receiver along with the on/off operation of the ignition switch.
TERMINAL CONNECTIONS
it as illustrated.
Notes
head slot.
SPEAKER SYSTEMS
Notes
" terminals of the speakers to a common point.
Always use the independent leads for each speaker. In this case, redo the wirings.
KS-AX3204/KS-AX3202:
KS-AX3201D:
Declaration of Conformity with regard to the EMC Directive 2004/108/EC
Manufacturer:
JVC KENWOOD Corporation
3-12, Moriyacho, Kanagawa-ku, Yokohama-shi, Kanagawa 221-0022, Japan
EU Representative's:
Dear JVC Customer in USA,
ever necessary to correct a safety related condition in your product.
Please note that failure to register does not diminish any of your rights during the warranty
period.
Information on Disposal of Old Electrical and Electronic Equipment (applicable for
countries that have adopted separate waste collection systems)
your local authority for details in locating a recycle facility nearest to you. Proper
recycling and waste disposal will help conserve resources whilst preventing
detrimental effects on our health and the environment.
1
For Customer Use:
Retain this information for future reference.
Model No.
1212ATHHACTKK
EN, RU
© 2012 JVC KENWOOD Corporation
FUSE
40A
+ B
REM
GND
POWER
Remote turn-on line
JVC car receiver, etc.
mm
2
to 21 mm
2
mm
2
mm
2
Ω
Ω
Ω
Ω
2
to 3.3 mm
2
2
2
Advertisement
Table of Contents
Related Manuals for JVC KS-AX3204
Summary of Contents for JVC KS-AX3204
-
Page 1: Speaker Systems
The proper lead wire connected to each POWER terminal is as follows. to 21 mm a When you use JVC car receiver with a remote lead, connect to the REM terminal on this unit. INSTALLATION b When you connect a unit without a remote lead, connect to the accessory circuit of the car corresponding to your specific car. -
Page 2: Speaker Connections
2-speaker system—Normal Mode appropriate connection referring to the following diagrams. Ω Ω. Notes Å JVC car receiver, etc. ı Speaker input connector. Connector lead Receiver Line out Å When your receiver is equipped with line output. a White "LEFT (+)"... -
Page 3: Controls
CONTROLS KS-AX3201D 2-Subwoofer system (2 amplifiers) KS-AX3204 Ω Ω. Å HIGH HIGH JVC car receiver, etc. CROSSOVER INPUT SENS. INPUT INPUT INPUT INPUT SENS. CROSSOVER MONO MONO POWER ı Speaker input connector. Connector lead Receiver FRONT REAR Line out (Rear) a White "LEFT (+)"... - Page 4 Благодарим за приобретение аппаратуры JVC. KS-AX3204 KS-AX3202 При появлении вопросов или при необходимости получения информации относительно KS-AX3201D монтажных комплектов обратитесь к агенту по продажам автомобильных аудиосистем "JVC IN- CAR ENTERTAINMENT" или в компанию, поставляющую монтажные комплекты. FUSE В целях безопасности…. POWER Предохранитель*...
-
Page 5: 袩芯写泻谢褞褔械薪懈械 袛懈薪邪屑懈泻芯胁
KS-AX3202 ПОДКЛЮЧЕНИЕ ДИНАМИКОВ Система с двумя динамиками—Нормальный режим Ω Ω. схемами и выберите подходящее подключение. Примечания Å приемник JVC и т. п. ı сопротивления и. т. п. тепло проникает наружу, что может привести к несчастному случаю. К Приемник автомобиля. выход Å... -
Page 6: 协谢械屑械薪褌褘 校锌褉邪胁谢械薪懈褟
KS-AX3201D Система с 2 низкочастотными динамиками (2 усилителя) KS-AX3204 Ω Ω. Å HIGH HIGH CROSSOVER INPUT SENS. INPUT INPUT INPUT INPUT SENS. CROSSOVER приемник JVC и т. п. MONO MONO POWER ı К Приемник или Выход KS-AX3202 KS-AX3201D сабвуфера Шасси* HIGH...